Werbung
1
4
7
9
12
2
5
8
English
C L E A N I N G T H E H O S E A N D N O Z Z L E
The vacuum cleaner stops automatically if the nozzle, tube,
hose or filters and s-bag™ becomes blocked. In such cases,
disconnect from mains and allow to cool for 20-30 minutes.
Clear blockage and/or replace filters and s-bag™ and restart.
Cleaning tubes and hoses
1
2
3
Note: The warranty does not cover any damage to the hose caused by
cleaning it.
Cleaning the floor nozzle
3
Cleaning the power nozzle (certain models only)
4
5
6
6
7
8
Cleaning the turbo nozzle (certain models only)
9
Use a cleaning strip or similar to clear the tubes and hose.
It may also be possible to remove the obstruction in the hose
by squeezing it. However, be careful in case the obstruction
is caused by glass or needles caught inside the hose.
To avoid deterioration of suction power, frequently clean the
carpet/hard floor nozzle. The easiest way to clean it is by
using the hose handle.
Disconnect from the mains, and remove entangled threads
etc. by snipping them away with scissors.
Use a screwdriver to remove the nozzle cover.
Remove the brush cylinder and bearings, then clean as
necessary.
To clean the wheels, gently lever them from their mountings
and clean as necessary.
Replace the cover and make sure it is securely fastened.
Remove the nozzle from the vacuum cleaner tube and
remove entangled threads etc. by snipping them away with
scissors. Use the hose handle to vacuum the nozzle.
Werbung
