Dell PowerEdge SC1430 Aktuelle Informationen Seite 3

Table 2. System Setup Program Options
Option
Boot Sequence Retry
(Disabled default)
Integrated Devices Screen
Table 3 lists a new Integrated Devices screen option.
Table 3. Integrated Devices Screen Options
Option
I/OAT DMA Engine
(Disabled default)
Diagnostic Indicator Lights
During system startup, at the completion of POST, all four lights are immediately turned off. The lights
cannot be seen to illuminate as described in Table 1-5, "Diagnostic Indicator Codes During POST,"
in your Hardware Owner's Manual. For further information about codes that may be displayed before
and during POST, see "Diagnostic Indicator Codes" in your Hardware Owner's Manual.
NOTE:
Once the system completes POST, all diagnostic lights will be OFF.
____________________
Information in this document is subject to change without notice.
© 2006 Dell Inc. All rights reserved. Printed in Malaysia.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks
and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
Description
Enables or disables the Boot Sequence Retry feature. When set to Enabled, the
system reattempts the boot sequence after a 30-second timeout if the previous
boot attempt failed.
Description
Enables or disables the I/O Acceleration Technology (I/OAT) option. When set
to Enabled, I/OAT reduces system CPU usage for applications that use TCP by
offloading part of the TCP receive operation to the DMA engine.