Notice - Retevis Rb24 Bedienungsanleitung

Notice

RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE FOR TWO-WAY RADIOS
User' instructions should accompany the device when transferred to other users.
Unauthorized modification and adjustment
Changes or modifications not expressly approved by the party responsible for compliance may void the user's
authority granted by the local government radio management departments to operate this radio and should
not be made. To comply with the corresponding requirements, transmitter adjustments should be made only
by or under the supervision of a person certified as technically qualified to perform transmitter maintenance
and repairs in the private land mobile and fixed services as certified by an organization representative of the
user of those services. Replacement of any transmitter component (crystal, semiconductor, etc.) not
authorized by the local government radio management departments equipment authorization for this radio
could violate the rules.
Radio License
Governments keep the radios in classification. Two-way radios are only operated on authorized radio
frequencies that are regulated by the local radio management departments (such as FCC, ISED, OFCOM,
ANFR, BFTK, Bundesnetzagentur, and so on.). The detailed classification and the use of your two-way radios,
please contact the local government radio management departments. Use of this radio outside the country
where it was intended to be distributed is subject to government regulations and may be prohibited.
FCC Requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device
does not cause harmful interference. (Licensed radios are applicable);
Note: This equipment has been tested and found to comply with the limits for a Class B digital device. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CE Requirements:
•(Simple EU declaration of conformity) Shenzhen Retevis Technology Co., Ltd. declares that the radio
equipment type is in compliance with the essential requirements and other relevant provisions of RED
Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU; the full text
of the EU declaration of conformity is available at the following internet address: www.retevis.com.
•Restriction on putting into service
This product may be used in following countries and regions, including: Belgium (BE), Bulgaria (BG), Czech
Republic (CZ), Denmark (DK), Germany (DE), Estonia (EE), Ireland (IE), Greece (EL), Spain (ES), France (FR),
Croatia (HR), Italy (IT), Cyprus (CY), Latvia (LV), Lithuania (LT), Luxembourg (LU), Hungary (HU), Malta (MT),
Netherlands (NL), Austria (AT), Poland (PL), Portugal (PT), Romania (RO), Slovenia (SI), Slovakia (SK), Finland
(FI), Sweden (SE) and United Kingdom (UK).
For the intended country of use, please refer to the package.
•This radio equipment contains frequency bands that are subject to licensing procedures before it is allowed
to be operated. Please make sure you have a valid radio license or radio operator permit before use.
Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you
that all electrical and electronic products, batteries, or accumulators must be taken to
designated collection locations at the end of their working life. Do not dispose of these
products as unsorted municipal waste.
Dispose of them according to the laws and rules in your area.Iug
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical
and electronic products, batteries, or accumulators must be taken to designated collection locations at the
end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them
according to the laws and rules in your area.Iug
04