tMoUNTINGftJStROCfJONSCtsee
Voltage and polarity: Thesetmustbeconnected to a 12 V car battery withnegative
terminal to earth (car chassis)
• Remov
e
the'Security Card'beforeinstalling theset.
Warning: Toprevent s hort-circuiting, disconnect thenegative carbatteryterminal u ntil
the set has been mounted and connected.
•
INSTALLING
•Install themetalsleevein thedashboard(Fig. 1).
• Fixmetal s leeve intoplaceby pressing themetal t agsoutwards usinga screwdriver.
POWER SUPPLY AND LOUDSPEAKER CONNECTIONS (Fig. 2)
If yourcarisequipped withISOcarradioconnectors, simplyinsert t hemin connectors
A and B of thecarradio.If not,youcanuseanadaptor cable (see liston paged).
Connection
details
Power supply (connector A)
• RedJ'+12 V SW." [A71:Connect to a switched 12 V supply (switched on/off bycar
ignition).
• Yellow/red " +12 V PERM."[A41:Connect to a permanent 12 V supply. This supply i s
needed
for theset's memory. I t alsoensures thata CDchanger f unctions c orrectly.
• Brown "GROUND"
Loudspeakers (connector B) (only use 4 ohm loudspeakers)
- Donotconnect a nyof theloudspeaker leadsto earthor directlyto a booster/amplifier.
• Connecting 4 loudspeakers
Leh +
Front
Green[B5]
• Connecting 2 loudspeakers
Left +
Green [B5]
•
OTHER
CONNECTIONS
• Automatic Aerial (optionalconnection): T his radiocanprovide a 12V signal f or thecontrol
of an automatic motoraerialor thesupplyof anelectronic aerial.Do not use this connection
for the supply lead of the aerial motor!
• Insert t hesquare pin of theblue 'AUTO AERIAL' leadintohole4 of the10-pinconnector E
(Fig. 3).
• Insert t heflatpinfromtheotherendof thelead'intohole[A5]of thepowersupply connector A (Fig. 3 ).
• CD changer: Youcanconnect a CDchanger (D2Btype) to thisset(see themounting
instructions
for theCDchanger). I nsert t heplugfromtheCDchangerintoconnector C .
METAL
SLEEVE
[A8]: Connectto earth (car chassis).
Left —
Green/black [86]
(High-power
Left —
Brown/black [Bbl
Right+
Grey[B31
a
88
configuration)
Right +
Gr
[B31
Grey/black[BÅ]
Right —
Blue/ b lack[B2]
11