JVD RB3409 Bedienungsanleitung Seite 69

LCD), Press and hold "
will show an animation of the RF antenna symbol，the Weather Station will re receive the
wireless signal of the outdoor sensor.
F.Y.I.:
 when the wireless sensor set up different channels, the weather station "OUT" also want to
switch to the same channel. When there is no wireless sensor signal transmission on the
channel, "--" will be displayed in the channel of the weather station
Displaying temperature/humidity and temperature/humidity trend
 The current indoor temperature/humidity and the temperature/humidity trend (indoors) are
shown in the LCD display.
 After successfully connecting with the remote sensor, the weather station can display the
remote temperature/humidity and the temperature/humidity trend (remote)
 You may see the following displays:
:
The temperature/humidity is rising.
NO DISPLAY: The temperature/humidity is remaining constant.
: The temperature/humidity is falling.
Maximum/Minimum Temperature/Relative Humidity
 To toggle indoor/outdoor maximum, minimum temperature and humidity data, Press the "
button:
Once to show the maximum temperature and humidity values.
Twice to sow the minimum temperature and humidity values
Three times to return to the current temperature and humidity levels
 To reset the maximum and minimum temperature and humidity, Press and hold down the "
button about 2 seconds. This will reset all minimum and maximum data recorded to the current
displayed values.
F.Y.I.:
 If the temperature reading is below ranges, the LL.L will be displayed. If the temperature
reading is above ranges, the HH.H will be displayed.
 If the humidity reading is below ranges, the 19%RH will be displayed. If the humidity reading is
above ranges, the 96%RH will be displayed.
Comfort instructions
 Comfort level is calculated according to the humidity, a total of 5 levels.
RB3409
" button for 3 seconds to receive transmission manually. the "OUT"
69
▼
"
▼
"