Initial Operation - Jvd Rb3409 Bedienungsanleitung

Part C –Wireless Remote Sensor:
C1: LCD display – Temperature
C2: LCD display – Humidity
C3: Transmit signal LED
C4: "°C/°F" button
C5: "TX" button
C6: "CHANNEL 1 or 2 or 3" switch
C7: Battery compartment

Initial operation:

 According to the appearance of the Weather Station, the power adapter is inserted from the
B12 position, and the power supply of the power adapter is also noted.
 Open Weather Station battery compartment cover, open Weather Station battery compartment
cover, insert 2 x AA batteries observing polarity [ "+" and "–" marks]
 After the weather station is connected to the power supply according to the above two steps, all
the icons on the LCD display will light up for 3 seconds, you will hear the buzzer, and check the
indoor temperature, humidity and Pressure.
 The Weather Station will now start to make a connection to the outdoor remote sensor. This
operation takes about 3 minutes, and the RF receiving antenna icon "
house figure of "OUT" in the weather station display.
 This now, open Wireless Outdoor Sensor battery compartment cover, according to the channel
to be set, the channel of the sensor is set through the shift switch of the C6 position of the
sensor, and Insert 2 x AA batteries observing polarity [ "+" and "–" marks]
 When the wireless sensor is loaded into the battery, all the icon on the LCD display will briefly
light up for 3 seconds, and detect the temperature and humidity of the sensor, At the same time,
LED lights flicker once, the wireless sensors automatically transmit wireless signals.
 When the Wireless Sensor is launched, the Weather Station alarm automatically receives its
signal, and the "OUT" column displays the temperature and humidity values.
RB3409
55
" flashes above the