Additional Battery Safety Warnings; Intended Use; Transporting Lithium Batteries - Ryobi Rsm4-120G Originalanleitung

EN ORIGINAL INSTRUCTIONS
Safety, performance, and dependability have been given top
priority in the design of your power spray mop.

INTENDED USE

The power spray mop is intended for the following purposes:
Mopping, washing, or cleaning of sealed hard surfaces
including hardwood, tile, vinyl, and laminate
Use only the recommended cleaning solution. Do not use
other chemicals as this may damage the internal parts of the
product and void your warranty.
Do not use the product for any other purpose.
POWER SPRAY MOP SAFETY WARNINGS
This product can be used by persons with reduced
physical, sensory, or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
product in a safe way and understand the hazards
involved. Children shall not play with the product.
The product is intended for household use only.
Do not use the product if it has been dropped, if there
are visible signs of damage, or if it is leaking.
Use extra care when using the product on stairs.
Rechargeable batteries are to be removed from the
product before being charged.
Exhausted batteries are to be removed from the
product and safely disposed of.
If the product is to be stored unused for a long period,
the batteries should be removed.
The supply terminals are not to be short-circuited.
The amount of the diluted cleaning solution must not
exceed max filling line shown on the cleaning solution
tank.
ADDITIONAL SAFETY WARNINGS
Do not clean over electrical outlets located on the
floor. Water may drip from the product after use
and can puddle. To avoid damage, do not place the
product on wood or laminate surfaces. If setting the
product aside for more than a few minutes, place it on
a towel or other absorbent material to catch any drips.
Failure to follow these rules may cause serious injury
or damage to property.
Apply the cleaning solution sparingly to complete
the task. Excessive foaming may occur if too much
cleaning solution is present.
During use, make sure the product does not get
submerged or doused in liquid, which could cause
shock, unit failure, or personal injury.
Do not direct liquid or steam towards equipment
containing electrical components.

ADDITIONAL BATTERY SAFETY WARNINGS

To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack, or charger in fluid or allow fluid to
flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and
labelling when transporting batteries by a third party.
Ensure that no batteries can come in contact with other
batteries or conductive materials while in transport by
protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries
that are cracked or leaking. Check with the forwarding
company for further advice.
KNOW YOUR PRODUCT
See page 44.
1. Battery cap
2. Spray button
3. Agitate button
4. LED button
5. Cleaning solution
6. Cleaning solution tank
7. Cleaning solution outlet
8. LED light
9. Floor head
10. Cleaning pad
11. Operator's manual
12. USB charging cable
13. Battery pack
14. USB power adaptor
MAINTENANCE
Use only original accessories and spare parts.
Should components need to be replaced which have
not been described, please contact an authorised
service centre. All repairs should be performed by an
authorised service centre.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal injury.
Before storing the product for a long period of time,
make sure that the water tank, cleaning solution tank,
and roller bar are cleaned and completely dried.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3