two trees TTS Produktanleitung Seite 9

3.3.2 Tensioner Installation
(j) You need to disassemble the tensioner first, unscrew the hand screw of the tensioner to take out the
Tensioner Inner Parts and unscrew the top screw to take out the idler.
Tensioner Internal parts
@ Put the timing belt of the carriage on the idler of the tensioner, and then lock the screw to the inner
part of the tensioner
@ Push the tensioner internals into the tensioner housing shell (Tensioner has a fixed slot, pay
attention to the installation method)
Tensioner has slot, pay attention to assemble them in
right direction and push them in into the right position
13
Tensioner shell
Thumb screws
Tensioner
housing shell
@ Lock up the tensioner retaining screws
screw M4*20 x2
The teeth of the timing belt should face the guide groove
EN
M4*20
0
14