two trees TTS Produktanleitung Seite 6

1.2 Install the frames
Screw M5*20x4
The countersunk head pore of Y-axis front
faces up. The profile scale is used to measure the size of the engraved
Y-a •s front profile
M5*20
1. First you need to install the frame while you don't
2. Make sure all profiles align.
07
profile faces inside. And the graduated side
object.
2] M5*20
M5*20
need to tighten the screws;
2. Install the foot pads
Screw M5*10x4
@ Push the foot pads in. First tighten the screw M5*IO in blue area, and then tighten the
screw M5*20 in green area
M5*10
Screw M5*20 x 4
@ Finally, tighten the M5*20 screws in red area. Note: Please follow the steps above to tighten
the M5*20 screws.
M5*20
M5*20
M5*20
M5*10
M5*10
M5*20
EN
08