two trees TTS Produktanleitung Seite 8

3.2 Push the carriage into the X-axis beam
The carriage pushes into the side
of the X-axis white terminal.
Rear view
11
The wire is between the X-axis beam
and the pom wheel
The frame seal is at the bottom,
and the cables to be placed in the seal
3.3 Placethe assembled carriage on the machine frame and hand-tighten the screws, then
assemble the tensioner.
The frames to
be aligned
well at slot
Black terminal should
be on the left side
3.3.1 Fixed X-axis beam
Align the X-axis beam Place the timing
with the slot belt on the profile
First screw two M4 * 50 screws to fix X axis beam (not too tight, adjust X axis beam parallel)
EN
Attention to the
carriage direction Whiteterminalshould
be on the right side
Check 3 3 2 for the guide on
tensioner installation.
isolation column 4*7*30 x 2
screw M4*SO x 2
12