JUNO JCF94181 Benutzerinformation Seite 11

Problem
Water flows onto the
floor
The lamp does not
work.
It is too warm in the
refrigerator
It is too cold in the
refrigerator
There is too much
frost and ice
It is too warm in the
freezer
It is too cold inside
the freezer
Possible cause
The melting water outlet
flows not into the evapora-
tive tray above the com-
pressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regula-
tor may be set incorrectly
The door does not close
tightly or it is not shut
properly
Food placed in the appli-
ance was too warm
Large quantities of food to
be cooled were put in at
the same time
There is no inside cool air
circulation
The Temperature Regula-
tor may be set incorrectly
Products are not wrapped
properly
Doors are not shut proper-
ly or do not close tightly
The Temperature Regula-
tor may be set incorrectly
Temperature Regulator
may be set incorrectly
The door does not close
tightly or it is not shut
properly
Large quantities of food to
be frozen were put in at
the same time
Food placed in the appli-
ance was too warm
Products to be frozen are
placed too closely to each
other
Temperature Regulator
may be set incorrectly
ENGLISH
Solution
Put the melting water outlet
to the evaporative tray
Close and open the door.
Refer to "Replacing the
lamp".
Set a lower temperature
Check if the door closes
well and the gasket is un-
damaged and clean
Allow food to cool to room
temperature before storing
Insert smaller quantities of
food to be cooled at any
one time
Provide inside cool air cir-
culation
Set a higher temperature
Wrap the products better
Check if the doors close
well and the gaskets are
undamaged and clean
Set a warmer temperature
Set a lower temperature
Check if the door closes
well and the gasket is un-
damaged and clean
Insert smaller quantities of
food to be frozen at any
one time.
Allow food to cool to room
temperature before storing.
Place the products in a way
so that cold air could circu-
late among them
Set a warmer temperature
11