Electrical Features; Instructions For Commissioning And Use; Mechanical Installation - SSD Drives AXEM MC 13S Handbuch

AXEM MC - MD

2.2.2 Electrical features

The values of rated characteristics are indicated on the name-plates of the motors and tacho-
generators.

2.3 Instructions for commissioning and use

2.3.1 Equipment delivery
All servomotors undergo a thorough quality control procedure before dispatch :.
- Check the condition of the servomotor by carefully removing it from its packaging ;
- Check that the information on the identification plate corresponds to your order. Check also the
accessories included in the box.
If the equipment has been damaged in transit, the recipient should immediately complain to the
carrier by registered letter within 24 hours.
2.3.2 Storage
Before installation, the servomotor should be stored in a dry place without large temperature variations
in order to prevent condensation.
If it is to be stored for a long time, check that the end of the shaft and the face of the flange are always
coated with an anti-corrosion product.
After lengthy storage (more than 3 months) rotate the motor at low speed
in the both directions to ensure even lubrication of the bearings.
2.3.3 Preparation
The installation must allow access to network engineering and it must be possible to read the
identification plate. Air must be able to circulate freely around the motor for cooling. For optimum
service life, motors should be protected from liquids and dust.
Clean the drive shaft using a cloth soaked in white spirit, alcohol or acetone, ensuring that no liquid
enters the bearings. The servomotor should be in a horizontal position during cleaning.
The servomotor position doesn't matter. The servomotor surface can reach temperatures of more than
100°C : act accordingly.
Avoid the servo motor to be put on materials which cannot stand high temperature.

2.3.4 Mechanical installation

- These motors can operate either in horizontal or vertical position. Bearings are fitted with ball-
bearings type LLB, for lifetime lubrification, including a spring washer for axial pre-loading.
Axial load, thrust and traction must not exceed the maximum allowable operating axial play mentioned
on data sheets.
Please, consult us in case of higher values.
Warning : the construction type of these motors prohibits impacts on the shaft end when installing the
accessories (pulley, coupling, capstan, pinion, etc.).
- Mounting flanges are of circular type, with tapped holes, and square flange, with clearance holes.
7
PVD 3204 01/2003