UbiBot GS2 Benutzerhandbuch Seite 6

Reset to Default Settings
Switch the device off, then press and hold the menu button and the power button together for at
least 8 seconds. Releasethe buttons when you hear the voice guidance. "The device will now reset."
„—m ALLSTOREDDATAWILL BELOSTIFYOU RESET YOURDEVICE TO DEFAULT SETTINGS!
REMEMBER TO SYNCHRONISE
IMPORTANT
BEFORE RESETTING IT.
* Note: If the conductivity
for measurement, it is recommended
accurate determination
CALIBRATION
1.0nline Web-Console
Once the device has been registered, please log in to the web console at
http://console.ubibot.com/login.html
2.PC tool calibration
Please download the UbiBot PCTool, connect the device, and follow the instructions to calibrate the
conductivity and PHvalues.
3.0ffline Calibration
f the device operation environment has limited access to the network, you can also use offline
calibration by following the instructions below.
• Conductivity Offline Calibration
0) Pour the appropriate amount of the conductivity calibration solution into the container.
@ Wash the conductance electrode with distilled water and wipe it clean to ensure that there is no
dirt or other attachments
@ Put the conductance electrode and the temperature probe into the calibration solution, and let
them restin the solution for 5 minutes at room temperature. The optimal temperature of the calibra
tion solution is 250C
THE SENSING DATA TO THE UbiB0t•
electrode and the PH electrode are placed in the same liquid at the same time
to set the acquisition
of measured values.
INSTRUCTIONS
Calibration
and follow the conductivity and PHcalibration instructions.
on the surface of the electrode.
IoT PLATFORM OR EXPORT
period to 5 minutes or above to ensure
4
ENGLISH
THE DATA TO YOUR COMPUTER