UbiBot GS2 Benutzerhandbuch Seite 5

ENGLISH
Switch Off
Press and hold the power button for 3 seconds until the screen is off. The device is now off.
Device Setup Mode
With the device switched on, press and hold the menu button for 3 seconds. Once the APicon starts
flashing on the screen, releasethe button.
Manual Data Synchronization
With the device switched on, pressthe power button once to trigger a manual data sync.The icon
will flash while the data is being transferred. Youcan also hear the voice guidance.
Update Readings
Pressthe menu button once, the device reading will be updated to real-time data.
Switch On/Off Voice Guide
Doub e press the menu button to enable or disable the voice guide. This will also refresh the last
sensing data.
Toggle Celsius or Fahrenheit
Doub e press the power button to togg e between crsp aying Celsius or Fahrenheit. This will also
refresh the last sensing data.
Display Backlight
Pressingeither the menu button or the power button will switch on the display backlight for a short
time. Pressing both of the two buttons at the same time will keep the backlight alight constantly.
Pressingboth buttons again will switch off the backlight.
Conductivity Measurement
Place the conductance electrode and the temperature probe in the solution to be measured, and
make sure they are close to each other. Takethe readings from both instruments at the same time.
Let the instruments rest in the solution for 5 minutes, and then press the device menu button to
refresh the measured data.
PH Value Measurement
Placethe PHelectrode and the temperature probe in the solution to be measured, and make sure
they are close to each other. Let them rest in the solution for 5 minutes, and then press the device
menu button to refresh the measured data.
3