What Is Included In The Box; Front Panel; Rear Panel - Sharp Rp-Tt100 Bedienungsanleitung

5
CE and UKCA statement:
• Hereby, Sharp Consumer Electronics Poland sp. z o.o. declares that
this audio device is in compliance with the essential requirements and
other relevant provisions of RED Directive 2014/53/EU and UK Radio
Equipment Regulations 2017.
• The full CE text and UKCA declaration of conformity are available at
sharpconsumer.com and then entering download section of your
model and choosing "Declaration of Conformity".
ERP II NOTE:
• This unit is designed to enter STANDBY mode automatically after
approximately 15 minutes of inactivity. Press the POWER button to
turn the unit on.

What is included in the box:

• RP-TT100 Automatic turntable
• Platter (with drive belt)
• Rubber platter mat
• Spare drive belt
• Dust cover
• Dust cover hinges x2
• 45 RPM adapter
• AC adapter
• Remote control (inc. batteries)
• Needle brush
• User documentation
Controls

Front panel

(Refer to 1 on page 1)
1. 45 RPM adapter store hole
2. Spindle
3. Platter
4.
/ Skip control knob. Rotate left or right to make the
tonearm one step. Rotate left or right and hold to make the
tonearm keep moving
5. Dust cover hinge slots
6. Tonearm
7.
button. Short press to switch between 7" and 12" record
8.
button. Short press to switch between 33 1/3 or 45 RPM
9. Tonearm rest
10. Cartridge
11. Short press to begin or stop playback.
12. Short press to lower or raise the tonearm.
13. Short press to enable or disable the repeat mode.
14. Select Bluetooth mode. Press to activate the pairing function in
Bluetooth mode or disconnect the existing paired Bluetooth device.
15.
Switch the unit between ON and STANDBY.
16. IR Sensor

Rear panel

(Refer to 2 on page 1)
1. DC IN 12V - Socket for connecting power adapter (DC 12V, 1A).
2. USB - Connect a USB-C cable to a PC to enable real-time recording.
3. GAIN SELECT Switch - If the record is recorded quietly, set volume
adjustment to HIGH.
If the record is recorded loudly, HIGH setting may cause distortion.
Select volume setting appropriate to the record for correct playback
level.
4. PREAMP Switch - If using an amplifier with a PHONO input jack, set
this switch to the PHONO position. If connecting to the AUX jack of
an amplifier, set this switch to the LINE position.
5. RCA L+R output - Connect to an external audio device
6. Ground Terminal - When using an external preamp, using a ground
cable connect to the ground terminal on the back of the turntable
and also connected to the external preamp.