Hamron 030803 Bedienungsanleitung Seite 7

● For maximum lifespan and performance of the
product, keep the operation environment clean and
with constant temperature and humidity.
● Do not use the product near volatile gas or in a
flammable atmosphere.
● Do not use the product if you are tired, ill, or
intoxicated. This will decrease your vision, alertness,
coordination and judgement.
● Do not let children or persons who do not know the
product to use it.
● Do not use the product if it is damaged.
● Do not make changes to the product.
● Use the product only for its specified function.
3 Operation
Warning! If you do not obey these instructions,
there is a risk of death or injury.
● Hang the product on the hanger during operation. If
not, the height from the ground of the power outlet
must not be higher than the length of the input wire.
● Do not put the product in the vehicle or other small
areas during operation.
3.1 To start the charging
1
Connect the input plug to the power outlet.
(Figure 2)
2
Push the mode button to set the applicable
current. The product can be set to 8 A, 10 A, 13 A,
or 16 A. (Figure 3)
Note! The default current is 8 A.
3
Push and hold the mode button until the charging
time, 2:00, is shown on the display. The charging
starts.
4
To set the charging time, push the mode button
until the applicable charging time is shown on the
display. The time starts to count down after a few
seconds.
5
Remove the protective cap and connect the
output plug to the vehicle. (Figure 4)
3.2 To stop the charging
1
Disconnect the output plug from the vehicle.
2
Disconnect the input plug from the power outlet.
3
Attach the protective cap to the outlet plug.
4 Storage
● If the product is not going to be used for a long period
of time, keep the product in a clean and dry area,
where children and pets do not have access to it.
5 Maintenance
● Clean the product with a damp cloth if necessary.
● Check the product for visible damage before you use
product.
● Make sure that the safety devices of the electrical
system are available and not missing before you use
the product.
6 Troubleshooting
6.1 To do a self-test
1
Make sure that the input plug is connected to the
power outlet.
2
Make sure that the output plug is connected to the
vehicle.
3
Do a check if the vehicle has requested to start the
charging.
EN
SV
NO
DA
PL
DE
FI
FR
NL
7