Overload Protection; Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch Xeo Originalbetriebsanleitung

OBJ_BUCH-377-008.book Page 22 Friday, October 21, 2016 11:29 AM
22 | English
Thin materials, such as fabrics, can be pulled into the machine during cutting and be-
come wedged. Therefore, do not apply too much pressure with such materials in or-
der to achieve good cutting results. During cutting, apply sufficient tension while
holding fabrics and cut slowly.
Optimum cutting results are best determined through practical testing.

Overload Protection

When the load on the machine is too high, the battery charge-control indicator 7
flashes red and the power tool switches off automatically.
– To start the operation of the machine again, relieve the load on the power tool first
and then switch on again (press ON/OFF switch 1).
The battery charge-control indicator lights up green again.
"Cut Control" Cutting-line Mark
The red line on the blade guard ("Cut Control" cutting-line mark 6) indicates the cut-
ting line of the blade 4.
This allows for precise guiding of the machine alongside the cutting line marked on
the material.
Cutting with the Cutting Adapter (Accessory) (see figures C1–C2)
The cutting adapter 12 enables you, as an example, to cut flooring alongside a wall.
After cutting, the flooring will have the optimal clearance of 3–5 mm to the wall (ex-
pansion joint).
– Firstly, cut the flooring 5–8 cm above the desired edge.
– To fasten the cutting adapter 12 to the machine, insert the guide edge 5 to the
stop into the opening of the cutting adapter.
– Position the cutting adapter flush between wall and floor.
The imprinted arrow must face towards the floor ("
– Switch the machine on and guide the cutting adapter slowly alongside
the wall.
Note: Take care that the cutting adapter is always guided flush to the wall and the
floor, and that the flooring is always positioned firmly against the cutting adapter.
Otherwise, precise cutting to length is not possible.

Maintenance and Service

Maintenance and Cleaning

 Warning! Prior to any maintenance and cleaning, switch the machine off and
secure the lock-off button 2.
 For safe and proper working, always keep the machine clean.
While cutting, material residue can accumulate under the blade guard.
– Clean the blade guard 3 regularly using a brush or lightly moistened cloth.

After-sales Service and Application Service

Our after-sales service responds to your questions concerning maintenance and re-
pair of your product as well as spare parts. Exploded views and information on spare
parts can also be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions concerning our prod-
ucts and their accessories.
In all correspondence and spare parts orders, please always include the 10-digit ar-
ticle number given on the nameplate of the product.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
1 609 92A 1M7 | (21.10.16)
").
Floor
Bosch Power Tools