EWT RB2M Bedienungsanleitung Seite 6
SPECIFICATIONS
Model
Part number
Power
Speakerpower
Remote control
Oscillation
Timer
Handle
Overheating protection
Anti-tilt protection
Voltage
Frequency
Product dimensions (LxDxH)
Product weight
INSTRUCTIONS
FOR USE
BEFORE
USING
APPLIANCE
1. Please read these instructions carefully before using the
appliance and keepthem for future use.
2. Check that the voltage of your local electricity network
complies with the one which appears on the appliance.
3. Before using the appliance for the first time, remove the
appliance's protective films or stickers.
4. Please
check
that
switches
position.
When the appliance is plugged in, press the button (7) to
switch
it on.
The appliance will select 25T as the default temperature.
The heater will then be in standby mode. Press the
button to switch
it on and activate
other buttons on the control panel.
MODE
CONTROL
When the appliance is switched on, the default operation
mode will be Fan
mode.
Press the
button to changethe mode.
Press it once to switch to Heating mode on speed 1 (low
heating
)
andthescreen w illdisplayW:
Press it twice to switch to Heating mode on speed 2 (high
heating
)
andthescreen w illdisplay•Y:•Y:
Press it three times
to return to Fan mode
will display
6
ROBO 2200 MUSIC
2200W
Yes - with CR2025battery
220 - 240 v-
L24 x D24x H64 cm
2.68 kg
FOR THE FIRST
TIME
on the
side
are on OFF
the touch function
and the screen
TTIMER
Press the
button to set the timer and programme when
the appliance should stop functioning. The timer can be set
for a period of up to 8 hours with I-hour intervals.
RB2M
Whenthe timer is activated,the
on.
To stop the timer, press
O hours.
OSCILLATION
Yes
The
allows you to switch oscillation of the appliance on
or off.Whenoscillationisswitchedon,the O will belit up on
8H
the LEDdisplay screen.
Yes
WIRELESS
Yes
This mode allows the appliance's speaker to be connected
to a smartphone or a tablet via wireless connection, allowing
Yes
you to listen to music or the radio.
Press the
symbol on the control panel.
Select the name of the appliance "EWT RB2M" on your
50 HZ
smartphone or tablet.
Once the connection has been established, start and control
music or the radio on your smartphone or tablet.
REMOTE
CONTROL
When inserting or removing the battery, please consult
the diagram below. Pay attention to the guide on the lid
explaining the positioning of the positive and negative
symbols on the battery.
of the
SN
Removethe protective cover from the battery slot of your
2.
remote control and place the 3V CR2025inside.
3. Avoid dropping the remote control or allowing it to fall to
the floor.
Batteries contain materials that are dangerous for the
4.
DE
indicator light will switch
until the timer indicator reaches
ON/OFF
CONNECTION
Appliance On/Off
A.
A
8H Timer
B.
Oscillation
B
C.
Control of heating and
D.
c
fan modes
D
E.
Decrease
F.
Increase
Wireless
G.
control
CR2025
OPEN
PUSH
mode
connection
