Werbung
KREIOS
®
FRESNEL 80W RGBW
LED
W
RGBW
82
100 max 100-240
Control
DMX 512 / Display
The external surface of the unit may exceed
50°C; never handle the unit until at least
5 minutes have elapsed since the unit
was turned off . Never install the unit in
an enclosed area lacking suffi cient air fl ow. A good
air ventilation is essential for proper equipment work.
Connect to the power supply in accordance with
national regulations. If the power cable is damaged
please discard the luminaire. The light source of
this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire
shall be replaced. Do not operate the device or
accessories if show a damage - contact qualifi ed
service persons. Connection must be made to a
power supply system fi tted with effi cient earthing
(Class I appliance according to standard EN 60598-1).
It is, moreover, recommended to protect the supply
lines of the projectors from indirect contact and/or
shorting to earth by using appropriately sized re-
sidual current devices.
Barn Door
(optional accessory)
18
W
Vac
Hz
50/60
Power
PowerCON IN/OUT
5)
Optic
ø 112 mm Fresnel
Connectivity
XLR 5/3 pin f/m
-10°C – 40°C
4)
Software Update:
1. Install the KREIOS
(www.osram.com) on your local PC.
2. Connect the KREIOS
(available on request) interface to your local PC
by using a USB cable.
3. Connect the KREIOS
interface to the fi xture by using a DMX cable.
4. Send the new software update to the fi xture
by using KREIOS
(www.osram.com).
Zoom
kg
14-77° linear
4.6
T
T
a
c
≥ 60°C
®
USB-DMX driver
®
fi rmware update box
®
fi rmware update box
®
fi rmware upgrade program
6)
IP
20
T
s
-20°C – 70°C
Werbung
