RENPHO RP-FM069R Bedienungsanleitung Seite 12

TROUBLESHOOTING
Common
problems
The 1. Disconnected power or
appliance loose plug, causing poor
is not contact.
working. 2. The power switch is off or
the timer has been reset.
3. The motor automatically
shuts off due to the device
being on too long, activating
overheating protection.
The 1. Your foot is positioned at
massage the wrong angle.
intensity is 2. Suitable intensity level is
too high or not selected.
too low.
No heat or The heating function is
insufficient manufactured according to
heat. international safety
standards, which means it
may take a bit longer,
around 7-10 minutes,
before you start feeling the
heat.
The touch 1. The plastic film on the
panel is touch panel is not removed.
not 2. Fingers are wet.
working 3. Insufficient touch area.
properly.
Cause
EN-09
Solutions
1. Re-plug in the appliance.
2. Turn the power switch on
again.
3. Use the appliance after
the motor cools down.
1. Adjust the contact angle to
get the moderate intensity.
2. The appliance has 3
intensity levels. Choose the
mode you prefer. We
suggest starting with the low
intensity for a gentle
introduction.
If you press the foot cover
to see the light, the heating
is turned normally. The rate
of heating is related to the
environment. If you are in a
cold area, the heating time
may take longer.
1. Remove the plastic film
before use.
2. Dry your fingers before
touching the button.
3. Use your thumb to press
buttons to get better touch
sensitivity.