Please read below instructions and refer to below figures:
1. Touch the
or
2. And then by tapping the corresponding Oval/Triple zone control, the indicator will show the
hotplate states in turn, denoting different hotplate connections.
4. After 2 seconds, the indicator will show the heat setting level again. The zone selection is done.
Oval zone selection
Residual heat indicator
Once the surface temperature exceeds 60°C / 140°F, the residual heat indicator
(see figure) will activate, signaling that the hob is still too hot to touch.
It may be used, for example, to keep a small meal warm or to melt cooking
chocolate. The display remains lit until the hotplate has cooled sufficiently.
Over-temperature protection
Equipped with a temperature sensor, the hob can monitor internal temperatures and will
automatically cease operation if they exceed safe levels.
Setting the Hob
This part provides instructions on how to set the hotplates.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the ON/OFF button. An audible signal sounds. The indicator light above the
main switch lights up. The hob is ready for use.
To switch off: Touch the ON/OFF button and the displays go out. All hotplates are switched off.
The residual heat indicator
Starting to cook
1. After switching on the hob, touch the
power indicator will show "
2. Use the
and
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
3. To change the heat setting: touch the
The heat setting is accepted immediately.
Note: If you don't choose a heat setting within 30 seconds, the hob will
automatically switch off.
www.iamzchef.com
to activate the hotplate and set the heat setting.
remains on until the hotplates have cooled down sufficiently.
".
buttons to set the desired heat setting.
Email: info@iamzchef.com Whatsapp:+1 (838) 910 8317
English
Triple zone selection
button to activate the hotplate. The corresponding
or
button until the desired heat setting appears.
59
Facebook: amzchefappliance