How To Use - Jetdryer Dynamic Installations- Und Bedienungsanleitung

How to use

Slowly move your hands
under the hand dryer
Turning on continuous air heating
To turn on continuous air heating it is necessary
to disconnect the temperature sensor inside the device.
1. Remove the instrument cover according to the
instructions on page 4. and find the master controller.
2. Disconnect the temperature sensor cable from the main
sensor control units see figure. Replace the instrument
cover.
Disconnecting the teperature sensors must
be done by a qualified electrician in accordance
with the local laws and regulations.
Obsah balení
Hand dryer .....................................................
5x25 mm self-tapping screw ............................
5 mm wall plug ...............................................
Allen key .................................................... ...
User manual .........................................................
1
Turn hands palm up
and slow move your hands
upwards
main control board
6
Move your hands as if you are
washing them under a tap
fuse
EN
status
indication
ON /OFF
temp.
sensor
receiving
sensors
1 pcs
4 pcs
4 pcs
1 pcs
1 pcs