Cleaning & Maintenance - Jetdryer Dynamic Installations- Und Bedienungsanleitung

EN
Testing the hand dryer
1
Firm wall installation
Voltage of the supplied
2
electrical power
Supply power to the hand
3
Place hands under the hand
4
dryer, the hand dryer should
start blowing air
Cleaning & Maintenance
Clean the surface of the hand dryer with a dry.
Always use neutral cleaning detergents.
Do not use thinners, acids, organic solvents, alkalis,
concentrated preparations, toilet cleaners, abrasive pastes,
salts, detergents containing sand. Do not use plastic cleaning
brushes and abrasive sponges.
Otherwise the surface of the hand dryer may be
damaged.
If using chemical wipes, first verify suitability of use
as recommended by the manufacturer on the packaging.
Regular maintenance is important for the proper functioning of the device, especially
regular cleaning of the HEPA filter and pouring drip water from the container. Heavy
contamination of the filters can lead to irreversible damage to the device!
1. Removing the case cover according to the steps
as mention on page 4. and remove the HEPA filter
from its housing.
2. Cleaning the HEPA filter
• The HEPA filter can be cleaned with a slight tap or by using
a vacuum cleaner. You can also use a fine brush.
• It is recommened to clean the HEPA filter reguraly every
3 months or if there is a noticable reduction in performance.
3. Install the HEPA filter back in place and reinstall
the case cover according to thr steps found on
page 4 of this user manual.
Before removing the case cover, make sure that the unit is disconnected from the
power supply. There is a risk of electric shock!
Step
Check to see if the unit is firmly
attached to the wall by trying to
Check using a voltmeter that
the supplied power is within
Plug the power cable into the
power socket or turn on the
dryer circuit breaker/power switch
Air blows out of the nozzle
Check
move it
AC 220-240 V
/circuit protection
5
Result
If the unit is not firmly attached to the
wall, vibrations can be visible and the
unit can make an unpleasant noise
The unit can catch fire or be
irreparably damaged if an incorrect
voltage is used
The hand dryer does not work.
Check the power connection of the
power LED is not lit
Air does not blow when hands are
placed below the sensor
1
Motion sensor
2
HEPA filter