Fillauer Dynamic Walk Produkthandbuch Seite 9

Specifications and Preparations Before Use
Fitting the Dynamic Walk
Single Side
1 . Remove the insole from the shoe .
2. Place the orthosis with the insole on top of it into the shoe .
3. Open the shoe and put your foot into it .
4 . Grab the calf band and pull it behind your calf . Tighten the shoelaces, (it´s important
that the shoe is tight enough to hold the orthosis in position while you are walking) .
5 . Now you are done and can start using the orthosis .
Standard Wide Ankle
1. Remove the insole from the shoe .
2. Place the orthosis with the insole on top of it into the shoe .
3. Place the toe of the opposite foot on the shoe for stabilization . Open the shoe widely
and grab the calfband with your hand .
4. Put your foot into the shoe and leave the calfband on your calf .
5. Tighten the shoe laces, (it is important that the shoe is tight enough to hold the
orthosis in position while you are walking .)
6. Now you are done and can start using the orthosis
9
9