Fillauer Dynamic Walk Produkthandbuch Seite 6

Casting Guide for Custom Dynamic Walk
To make the right heel height and toe lift, use the following materials: plaster, stocking,
pen, knife and footplate .
1. Take all the measurements on the measurement form
2. Put on the stocking and mark the malleolus, the MTP joint and other
prominent bones
3. Make a 4-layer thick plastercast and it should have the height of the tuberositia tibia
4. * Put the foot on the plate, 90 degrees in the foot and knee . Remember to have a
neutral position in the mediolateral plane to . Get the patient to put some weight on
the leg still seated
5. Take off the cast
6. Reinforce the cast with 2 layers of plaster
Consumable Components
Padding and straps can be ordered separately .
Disposal/Waste Handling
The product must be disposed of in accordance with applicable local laws and
regulations. If the product has been exposed to bacteria or other infectious agents,
it must be disposed of in accordance with applicable laws and regulations for the
handling of contaminated material .
If possible, recycle the device per material as follows:
Plastic material as plastic and the carbon fiber as metallic waste.
6
6