Replacing The Lamp - Sony Grand Wega KF-42SX200 Bedienungsanleitung

Additional Information

Replacing the Lamp

When the lamp becomes dark or the picture colour is
not normal or the lamp indicator
flashes, replace with a new lamp.
• Only use the lamp XL-2000E for replacement. If you
use another lamp, it may cause damage to the TV set.
• Do not remove the lamp except when replacing it.
• Before replacing the lamp, turn off the power and
disconnect the power cord.
• Replace the lamp only after it becomes cool. The front
glass of the lamp remains at least 100 °C (212 °F) even
after the power has been turned off for 30 minutes.
• Do not place the old lamp in proximity to children or
flammable material.
• Do not get the old lamp wet, or insert objects inside
the lamp. It may cause the lamp to explode.
• Do not place the old lamp near easily flammable
objects, as this may cause fire. Also, do not put your
hand inside the lamp compartment, as you may be
burned.
• Attach the new lamp securely. If it is not securely
attached, the picture may become dark.
1
Turn off the power and disconnect the power cord.
• If you start changing the lamp without disconnecting
the power cord, the standby indicator
flashes. Disconnect the power cord to continue
changing the lamp.
• Replace the lamp 30 minutes or more after the power
is turned off to allow it to cool.
• Prepare the new lamp.
2
Remove the front panel.
Remove the front panel without moving the TV set.
Grasp the right side of the front panel with your fingers
and pull it forward. Be careful not to catch your
fingernails.
34
Additional Information
3
on the TV set
4
on the TV set
5
6
7
Notes
•
•
•
•
•
Loosen the screw with an object such as a coin and
remove the lamp cover.
Loosen the two screws and pull out the lamp.
Loosen two screws with the hexagon key supplied.
Pull out the lamp by the handle.
The lamp is still extremely hot immediately after the
power is turned off. Be careful that you don't touch
the front glass or surrounding area of the lamp or the
glass of the lamp compartment.
Attach the new lamp.
Replace the new lamp securely in the lamp receptacle and
fasten the screws tightly using the hexagon key supplied.
Attach the lamp cover.
Fasten the screw tightly with an object such as a coin.
Attach the front panel.
Attach the front panel locating the left hand edge of the
cover first and then pushing the right hand side back into
place.
Do not touch or stain the front glass of the new lamp or the glass
of the lamp compartment. If the glass become dirty, the picture
quality may deteriorate or the lamp life may shorten.
Attach the lamp cover firmly. If it is not firmly attached, the
power will not turn on.
When the lamp burns out, a noise is audible. This does not
indicate damage to the TV set.
Consult your nearest Sony service center to obtain a new lamp.
Always remember to dispose of used lamps in an
evironmentally friendly way.