Messages - Sony MEX-N4200BT Bedienungsanleitung

 If the BLUETOOTH audio device is stored in
a case which interrupts the signal, remove
the audio device from the case during use.
 Several BLUETOOTH devices or other
devices which emit radio waves are in use
nearby.
– Turn off the other devices.
– Increase the distance from the other
devices.
 The playback sound stops momentarily
when the connection between this unit
and the cellular phone is being made. This
is not a malfunction.
The connected BLUETOOTH audio device
cannot be controlled.
 Check that the connected BLUETOOTH
audio device supports AVRCP.
Some functions do not work.
 Check if the connecting device supports
the functions in question.
A call is answered unintentionally.
 The connecting phone is set to answer a
call automatically.
Pairing failed due to a timeout.
 Depending on the connecting device, the
time limit for pairing may be short.
– Try completing the pairing within the
time.
BLUETOOTH function cannot operate.
 Turn off the unit by pressing OFF for more
than 2 seconds, then turn the unit on
again.
No sound is output from the car speakers
during handsfree call.
 If the sound is output from the cellular
phone, set the cellular phone to output
the sound from the car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an
iPhone that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with
the iPhone and the unit, and reconnect.
30
GB
SongPal operation
Application name is mismatched with the
actual application in "SongPal".
 Launch the application again from the
"SongPal" application.
While running the "SongPal" application
via BLUETOOTH, the display automatically
switches to [BT AUDIO].
 The "SongPal" application or BLUETOOTH
function has failed.
 Run the application again.
The "SongPal" application is automatically
disconnected when the display switches
to [IPD].
 The "SongPal" application on iPhone/iPod
does not support iPod playback.
– Change the source of the unit to other
than [IPD], then establish the "SongPal"
connection (page 16).

Messages

The following messages may appear or flash
during operation.
CD ERROR: The disc cannot be played. The
disc will be ejected automatically.
 Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO MUSIC: There is no playable file. The
disc will be ejected automatically.
 Insert a disc containing playable files
(page 25).
CD PUSH EJT: The disc could not be ejected
properly.
 Press  (eject).
HUB NO SUPRT: USB hubs are not
supported.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during
iPod playback.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start
playback.