Troubleshooting; Technical Data - Walter Wws-Kll-R01 Bedienungsanleitung

Troubleshooting

Troubleshooting
Problem
No laser beam or weak
laser beam
Automatic levelling not
possible
Laser lines not level
horizontally or
vertically
Horizontal laser line
partly broken

Technical data

Line laser
Model
Input voltage
Laser colour
Working range (Distance to wall)
Laser line accuracy
Levelling precision
Output power:
Levelling duration
Laser class:
Wavelength
Operating temperature
Air humidity
Tripod
Model
Height adjustment
24
612691_Anleitung_Kern.indb 24 612691_Anleitung_Kern.indb 24
Possible cause
Battery low
Line laser faulty
Product not switched on
Product not switched on
Laser's freedom of movement
in automatic levelling mode
impaired.
Glass cover dirty
WWS-KLL-R01
3V
red
max. 10 m
(+/-) 0.5 mm/m
+/-3°
< 1mW
< 6 sec.
II
635 nm
5°C to 40°C
max. 80% up to a temperature of 31 °C linearly
decreasing up to 50% humidity at 40 °C
WWS-KLS-R01
54-158 cm
Rectification
Replace the battery
Contact the service centre
Switch on the product as described in the
"Switching on and off" chapter.
Switch on the product as described in the
"Switching on and off" chapter.
Position the laser so that the maximum
inclination angle of 3° is not exceeded.
Clean the glass cover as described in the
"Cleaning" chapter
(Two 1.5V-LR6 (AA))
20.10.2023 11:55:07 20.10.2023 11:55:07