Fine Adjustment Of The Tripod (Fig. F-I); Switching On / Off (Fig. J); Switching On - Automatic Levelling; Switching Off - Automatic Levelling - Walter Wws-Kll-R01 Bedienungsanleitung

Usage
Fine adjustment of the tripod
(Fig. F-I)
You can make fine adjustment to the tripod
vertically and horizontally using 3 adjustment
screws:
(1a) Height adjustment - fast (Fig. F):
• Loosen the adjustment screw A 8 in
counter-clockwise direction.
• Pull the telescopic arm 13 out of the
housing to the desired height.
• Tighten the adjustment screw A clockwise.
(1b) Height adjustment - fine (Fig. F):
• Turn the hand crank 14 clockwise to raise
the telescopic arm or counterclockwise to
lower it.
(2) Tilt up/down (Fig. G):
• Turn the handle 7 counter-clockwise and
tilt the tripod head 6 up or down.
• Fix the position by tightening the handle
counter-clockwise.
(3) Rotation right/left (Fig. H):
• Loosen the adjustment screw B 15 in
counter-clockwise direction.
• Turn the tripod head to the right or left.
• Tighten the adjustment screw B clockwise.
(4) Horizontal tilting (Fig. I):
• Loosen the adjustment screw C 5 in
counter-clockwise direction.
• Tilt the tripod head.
• Tighten the adjustment screw C clockwise.
22
612691_Anleitung_Kern.indb 22 612691_Anleitung_Kern.indb 22

Switching on / off (Fig. J)

WARNING!
Never look directly into the laser
beam or into the laser window
CAUTION!
Point the laser away from you when
switching the line laser on.

Switching on - automatic levelling

• Slide the lock 20 to the
- Automatic levelling starts. The 21 LED
button turns red and the laser lines flash.
- Automatic levelling is complete when the
lines stop flashing and the LED button turns
green.
- If the LED turns red and the line lasers are
still flashing after about 10 seconds, then
automatic levelling has failed.
- Reposition the line laser and start the
process again.
Switching off - automatic
levelling
• Slide the lock to the position.

Switching on - manual levelling

• Slide the lock to the position.
• Press the LED button.
- The LED button is continuously red during
manual levelling.

Switching off - manual levelling

• Press the LED button.
.
3
position.
20.10.2023 11:55:06 20.10.2023 11:55:06