DUROFIX RI60165A1 Bedienungsanleitung Seite 7

can make a connection from one terminal to another. Shorting the battery
terminals together may cause burns or a fire.
e) Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected from the battery may
cause irritation or burns.
f) Do not use a battery pack or tool that is damaged or modified. Damaged or
modified batteries may exhibit unpredictable behaviour resulting in fire,
explosion or risk of injury.
g) Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 130 °C may cause explosion. NOTE The
temperature 130 °C can be replaced by the temperature 265 °F
h) Follow all charging instructions and do not charge the battery pack or tool
outside the temperature range specified in the instructions. Charging
improperly or at temperatures outside the specified range may damage the
battery and increase the risk of fire.
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel may result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instructions
in the Maintenance section of this manual. Use of unauthorized parts or failure to
follow Maintenance Instructions may create a risk of shock or injury.
SPECIFIC SAFETY RULES AND SYMBOLS
CAUTION
Hold tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring. Contact with 'live' wire will also
make exposed metal parts of the tool 'live' and shock the operator.
Be aware that this tool is always in an operating condition, because it does not
have to be plugged into an electrical outlet. Always set the trigger switch to the
locked OFF position when installing or removing the battery pack or bits.
Do not use bits or sockets larger than those recommended. Large bits or drills
may overload the wrench/driver and damage the motor and gears.
Do not use if chuck jaws or other parts are cracked or worn.
Never change direction of rotation until motor has completely stopped.
1English1
SERVICE
English -6