Mapal Hydro-TurnChuck Montage- Und Betriebsanleitung Seite 54

5 5 . . 3 3 V V D D I I c c o o n n n n e e c c t t i i o o n n – – C C l l a a m m p p i i n n g g a a t t o o o o l l s s h h a a f f t t a a s s p p e e r r D D I I N N 1 1 8 8 3 3 5 5 / / D D I I N N 6 6 5 5 3 3 5 5
5 5 . . 3 3 . . 1 1 C C l l a a m m p p i i n n g g p p r r o o c c e e d d u u r r e e
EN
W W A A R R N N I I N N G G
I I n n s s u u f f f f i i c c i i e e n n t t c c l l a a m m p p i i n n g g u u p p t t o o t t h h e e s s t t o o p p a a n n d d f f a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e m m i i n n i i m m u u m m n n u u m m b b e e r r o o f f t t u u r r n n s s ! !
Insufficient clamping up to the stop and failure to observe the minimum number of rotations can cause the workpiece to
fly off like a projectile and cause serious injuries.
 During clamping, screw in the clamping screws up to the stop, observing the specified minimum number of rotations
section 4.4
(see
 Before the first clamping the clamping screw that may possibly be inaccessible once mount clamping screw must be
fully tighten.
Tightening clamping screw 1
54 54
).
I I N N F F O O R R M M A A T T I I O O N N
The clamping screws are not captive!
Ensure that the clamping screws are clean.
Set a torque wrench to a tightening torque of 7 7
Tighten the clamping screw 1 to the stop with the aid of the torque
wrench.
Nm
Montage- und Betriebsanleitung Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions