VEVOR TD-003-05FR Bedienungsanleitung Seite 6

Assembling Instructions of the Rear Stand
A. Assemble the wheels on both sides of the frame and then Insert both pieces of
frames.
B. Place M8 screws through the holes of clamping pieces and the frame, and
make sure that the connecting part are covered with clamping pieces on both
sides. Then add washers and use tools to tighten with the lock-nuts.
C. Loose the both sides screws on the top of the frame with wheels, insert the
correct adaptors (paddle adaptors or fork adaptors) which can fit your
motorcycle.
Operation of the Rear Stand with Paddle Adaptors
A. Loose the screws on the top so that the position of adaptors can be adjusted.
B. Roll the stand and make sure your motorcycle rear wheel is in the middle of
the frame.
C. Adjust the position of the paddle adaptors to match the width of your
motorcycle dual swing arm and then tighten the screw with plastic.
D. Rise the stand with handle and move the stand to where are under the swing
arm, then press down the stand in order to rise your motorcycle rear wheel.
Make sure the paddle adaptors are snug up against the swing arm.
Operation of the Rear Stand with Fork Adaptors
A. Loose the screws on the top so that the position of adaptors can be adjusted.
B. Roll the stand and make sure your motorcycle rear wheel is in the middle of
the frame.
C. Adjust the position of the fork adaptors to match the width of your motorcycle
bobbins on both sides and then tighten the screw with plastic.
D.
Rise the stand with circled handle and move the stand to where fork adaptors
are right under the bobbins, then press down the stand in order to rise your
motorcycle rear wheel. Make sure the fork adaptors are snug up against the
bobbins.
- 6 -