Object Detection Mode / Presentation Mode; Data Modification - Werock Rockscan W100 Betriebsanleitung

Rockscan W100 User Manual

Object detection mode / presentation mode

In this mode, the scanner activates decode processing when it detects a barcode in its field of view without
a trigger being pressed. After a period of inactivity, the scanner enters a low power mode in which the LEDs
remain off until the scanner detects motion. This mode is particularly useful for stationary scanners where
barcodes are presented for capture or very high volume scanning.
Scan the following barcode to activate presentation mode:
Presentation Mode

Data modification

This chapter describes the ways in which you can customize the scanned data to make your workflows
more efficient.
Add & Remove Prefix: Learn how to add or remove prefixes to your scanned data to better label it or
customize it to specific requirements.
Add & Remove Suffix: Learn how to add or remove suffixes to your scanned data to append additional
information or prepare it for specific systems.
Post-scan behavior: Discover the different ways your barcode scanner can react after scanning and how you
can customize these reactions to optimize your workflow.
99 / 130