Connecting The Scanner; Selecting The Transmission Mode - Werock Rockscan W100 Betriebsanleitung

To switch off the scanner, proceed as follows:
1. Press the trigger on the scanner or the connected wearable for about 6 seconds
2. The green light lights up once and the device vibrates briefly. Depending on the setting, you will also
hear a sound.

Connecting the Scanner

This chapter describes how to connect the Rockscan W100 barcode scanner to a computer, smartphone,
tablet or other compatible Bluetooth-enabled device.

Selecting the transmission mode

The Rockscan W100 barcode scanner supports various transmission modes. This chapter describes the
features and how the scanner can be set to the respective mode.
Bluetooth HID mode (Human Interface Device)
Function: The barcode scanner emulates a keyboard and sends the read barcodes as keyboard input to the
connected device. This mode is compatible with a wide range of devices that support keyboard input, e.g.
laptops, tablets, smartphones and POS systems. However, it has limited functionality as it only allows the
transmission of barcodes as keystrokes.
Scan the following barcode to enter Bluetooth HID mode:
Bluetooth SPP mode (Serial Port Profile) – COM Port Emulation
The barcode scanner establishes a serial connection to the connected device and sends the scanned
barcodes as a data stream via a virtual serial port. This mode enables flexible use, as the data can be used
in various applications, provided they are set up for this. Not all devices support SPP mode.
Scan the following barcode to enter Bluetooth SPP mode:
Rockscan W100 User Manual
Bluetooth HID mode*
Bluetooth SPP mode
89 / 130