Electrolux EQL4520BOZ Benutzerinformation Seite 18

18 www.electrolux.com
8.6 Installation of more than one
hob
Supplied accessories: connection bar,
heat-resistant silicone, rubber shape,
sealing stripe.
Use only a special heat-
resistant silicone.
The worktop cutout
Distance
from the
wall
Depth
Width
Example:
580 mm
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
3. One by one place the hobs on a soft
surface (for example on a blanket) with
the bottom side up.
4. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic.
minimum 50 mm
490 mm
sum of all widths of hobs
that you install minus 20 mm
+ - =
360 mm 20 mm
min.
25 mm
min.
2 mm
5. Loosely screw the fixing plates into the
correct holes in the protective casing.
6. Insert first hob into the worktop
cutout. Than insert the connection bar
into the worktop cutout. Push it half of
its width under the hob.
7. Loosely screw in the fixing plates from
below to the worktop and to the
connection bar.
920 mm
8. Insert next hob into the worktop
cutout. Make sure that the front edges
of the hobs are on the same level.