Sharp UA-PGSOE Bedienungsanleitung Seite 14

Before calling for service, please review the Troubleshooting list
be a unit malfunction.
SYMPTOM
Odours and smoke are not
removed.
The DUST AND ODOUR SIGN
illuminates green even when the air
is impure.
The DUST AND ODOUR SIGN
illuminates orange or red even
when the air is clean.
A clicking or ticking sound is heard
from the unit.
The discharged air has an odour.
The unit does not operate properly
when cigarette smoke is in the air.
The DUST AND ODOUR SIGN is
turned off.
The DUST AND ODOUR SIGN
changes colour frequently.
REMEDY (not a malfunction)
• Clean or replace the filters if they appear to be heavily soiled.
(Ref. E-8,E-9)
• The air could be impure at the time the unit was plugged in.
Unplug the unit, wait one minute, and plug the unit in
• Sensor operation is affected if the odour sensor and dust sensor
filter are dirty or clogged.
dust sensor filter. (Ref. E-9).
• Clicking or ticking sounds may be audible when the unit is
generating ions.
• Check to see if the filters are heavily
• Clean or replace the
filters.
• Plasmacluster Air Purifiers emit small traces of ozone which may
produce an odour. These ozone emissions are well below safety
level.
• Is the unit installed in a location that is difficult for the sensor to
detect cigarette smoke?
• Is the dust sensor filter blocked or clogged?
(In this case, clean the filter.)
• Check to see if the Lights OFF Mode is
Press@tor 3 seconds to turn light ON.
(Ref. E-7)
• Check to see if the SLEEP mode is selected.
The DUST AND ODOUR /PLASMACLUSTER SIGN are turned off
automatically after the SLEEP mode is
• The DUST AND ODOUR SIGN automatically changes colours
as impurities are detected by the dust sensor and odour
The sensor detection sensitivity can be adjusted
(Ref.E-7)
E-10
below, since the problem may not
Gently clean the odour sensor and
soiled.
(Ref. E-9)
selected.
selected.
lower.
again.
sensor.