Disposal Of The Appliance - Rommelsbacher Rk 501 Bedienungsanleitung

Coff ee leakage from the upper part:
- Do not leave Brikka on the heat source at the end of dispensing
and froth formation.
CLEANING AND MAINTENANCE
• Before carrying out cleaning and maintenance, allow the appliance to
cool down completely.
• It is advisable to clean the coff ee maker in all its parts, including
the dispensing column, which must be free from coff ee powder ob-
structions.
• After each use, wash with warm water without detergents and/or
abrasive materials (the product CANNOT be put in the dishwasher).
• Store the product perfectly dry in all its parts and not closed to pre-
vent any build-up of stains/oxidations.
• Regularly perform the decalci cation procedure:
1. Fill the heater with water as per normal preparation.
2. Add two teaspoons of citric acid or vinegar.
3. Reassemble the product and, without adding the coff ee powder,
dispense once.
4. Throw away the solution obtained.
5. Wash the coff ee maker with current water and make coff ee.
• Regularly check that the holes of the  lter plate (6) are not obstruct-
ed, otherwise open them using a brush with delicate bristles or a
needle.
• Periodically check the internal components and, in case of wearing or
damage, replace them only with original Bialetti spare parts suitable
for the model used.
• Replace the gasket (7), if worn. It is recommended to replace it at
least once a year anyway.

DISPOSAL OF THE APPLIANCE

• At the end of the life of the product, dispose it in a waste collection
centre.
• The adequate waste sorting and the correct disposal contribute to
avoid negative impacts on the environment and public health and
permit recycling of the materials which the product is made of.
• For more detailed information regarding the available collection sys-
tems, contract the local refuse centre or the store where the product
was purchased.
WARRANTY
The product is guaranteed for a period of 24 months from the date of
purchase, with the functional conditions as foreseen in this instruction leaf-
let. In case of claim for servicing under warranty, it is required to contact
the dealer or Bialetti Industrie Spa and provide proof of purchase or an
equivalent document showing the identi cation data of the dealer or the
date of purchase.
Warranty does not cover:
• The replaced components (plate, funnel, gasket, and handle) for
non-original defects.
• Failures and/or defects caused by an use, which is improper or
not-compliant with the instructions.
• Failures and/or defects arising from the use of non-COMPATIBLE
12
spare parts.
• Damages caused by impacts, falls, and lime scale deposits.
-
-
-
Si
m
La
-
-
-
La
-
-
La
-
-
Le
-
N
•
•
•
•
•
•
•
•
ÉL
•
•