Kiva SILVA R6 Benutzerhandbuch Seite 20

EN
a
cutting
adjustment
a
5.2
The machine
The machine stopped during
use
Heavy vibrations
Blade overheating
The blade gets stuck in the wood but the
engine is running
The blade is blackening the wood
The blade does
e Remov the
pin
Inspect the
machine
PROBLEMS
PROBLEM
does not start
not cut
MOVEMENT AND HANDLING
Transport
installation
Loading and
unloading
AND SOLUTIONS
PROBABLE CAUSE
- No petrol
- ON/OFF switch at 00 or OFF
Spark plug wire disconnected
Out Ofpetrol
Cutting efforttoo high
Cutting tool may be damaged
Cutting effort too high
The belt is slipping
The blade has lost its sharpness
- Blade fitted upsidedown
- Teeth blunt or blade damaged
- Wrong blade choice
handle
Handling: do not lift the machine on your
own. The machine's weight is indicated on
the manufacturer's plate and at the end of
this manual. Use a handling method that is
adapted to the machine's weight and the
situation in order to guarantee safety
- When loading or unloading the machine to
or from a trailer, use a suitable ramp and get
help from someone else
Stowthe machinecorrectlyfor safe transport
- Check that there is some petrol
Set the switch
- Reconnect the spark plug wire
Fill up with petrol and restart the engine
- Restart the engine
Change the blade or contact an approved
repair shop
Sharpen or replace the blade
Check that the tension spring is present
- Have the belt replacedby a professional
Have the blade sharpened by a professional
- Putthe blade back the rightway up
- Have the blade sharpened or replace it
Choose the right blade
SOLUTION
to -e or ON