Circuit Breaker - Kiva Silva R6 Benutzerhandbuch

EN
a
2.2
2.3
n
This machine is intended
- cut wood for heating
between 5 and 23 cm
This machine is not intended for professional
use
Before
Make sure that the machine
- Check that the bolts and screws
tightened
Check that
present and in good condition
Check the condition of the blade: always
use correctly sharpened blades
NOTE: If a dust suction system is used, the
rate must be over 1000 M3/h
Oil full and level
Petrol full
Super or unleaded or SP95 E 10
Open the fuel tap and set the
starter to position A
Accelerator
Set the lever to:
to:
to a diameter
use
is stable
have been
the protective casings are
MACHINE START-UP
a
2.5
2.6
2.7
USE
Sawing procedure:
I- Place the log to be cut to the end of the
cutting adjustment pin
2- Hold the log with the clamp
3- Push the bridge in the direction of the
blade
After cutting, wait until the bridge has
4-
returned to rest position before removing
the logs
If the blade gets stuck in a log, switch
off the engine then place both hands
on the 2 hands and pull back towards
you gradually until the
released
If the chips are removed incorrectly,
refer to points 1, 2 and 9 in the blade
change procedure

Circuit breaker

Set the circuit breaker to: ON
(Depending on engine type)
Pull the launcher
Always remain inside the safety zone when
the machine is starting up
Set the starter to position
a Usage p osition
ALWAYS place both hands on the 2
usage handles
rest position
3.2
blade is
Cutting position
3.3
handle
B