Tru-Test speedrite SG1 Bedienungsanleitung Seite 7

Changing the power level
1. Press to change between half power and full power.
The pointer changes to indicate half power
Changing the pulse speed
To change the pulse speed, press
Possible settings:
Fast
Daylight 1.5 s
Darkness 1.5 s
Note: In night mode, the energizer senses darkness using the light sensor and automatically changes the pulse speed. Ensure the light sensor remains clean
at all times, by wiping away any excessive dirt and water deposits off the top label.
Locking the energizer with a security code
1. Press and hold until the display turns on.
2. Press and together until the display shows zero and the padlock pointer flashes.
3. Press until the display shows the desired security code. This can be any number between 01 and 99.
4. Press three times to save the security code.
The display returns to normal with the padlock pointer on. The security code will now be required each time the energizer is switched on.
Changing the security code
1. Press and hold until the display turns on and shows two question marks
2. Press repeatedly until your security code appears on the display.
3. Press briefly to unlock and turn on the energizer.
4. Press and together until the display shows
5. Press until the display shows your current security code.
6. Press briefly. The display shows zero and the padlock pointer flashes.
7. Press until the display shows the new code number required.
8. Press three times to save the new security code.
The display returns to normal, with the padlock pointer on, indicating the security code feature is enabled.
Disabling security code feature
1. Press and hold until the display turns on and shows two question marks
2. Press repeatedly until your security code appears on the display.
3. Press briefly to unlock and turn on the energizer.
4. Press and together until the display shows
5. Press until the display shows your current security code.
6. Press briefly. The display shows zero.
7. Press three times.
The display returns to normal with the padlock pointer off, indicating the security code feature is disabled. A security code will not be required when the
energizer is switched on.
or full power
repeatedly until the two pointers ( ) on the right-hand side of the display indicate the required setting.
Slow
2.5 s
2.5 s
.
.
.
Night Mode
Fast
2.5 s
1.5 s
.
.
Night Mode
Slow
1.5 s
2.5 s
3