Smappee EV One Kurzanleitung

Smappee
EV One
Quick install guide
What's in the box?
2x
Door Door screw
4x
Anchor nuts Splitter
2x
Smappee QR code
EV One Charge Card sticker
Floorplate to install on a flat surface,
can be purchased seperately.
Floorplate
Smappee
EV One
Connection diagram
Network cable
In case of Wi-Fi or 4G,
consult the installation manual.
Network
cable
Power supply
cable
3 x 400 V + N L 3 L 2 L 1 N PE
1
1 x 230 V L N PE
3 x 230 V L 2 L 1 L 3 PE
1
B
A
2
A
B
3
EN
Safety warning
Carrying out electrical work within the home or workplace can be
dangerous and must be conducted according to the appropriate
national safety standards and executed by a certified electrician.
For safety purposes, it is also necessary to power off the
installation before proceeding with the physical installation.
Read the installation manual
carefully before proceeding
as it contains all the safety
and installation instructions.
This manual is available at
smappee.com/downloads or
via the QR code.
Prepare the installation
The EV One comes with a supplied anchor that can be mounted
in the ground. For dimensions of the hole, see the diagram. A floor
plate can be purchased separately to install the EV One on a flat
surface where the supplied anchor cannot be used. There must be
one power supply cable and one network cable. In case of Wi-Fi or
4G connectivity, please refer to the full installation manual.
Installation and configuration
1. Take the EV One out of its packaging. Unscrew the two bottom
screws and slide the outer housing upwards, off the internal
structure. Take the anchor out.
2. When using the supplied anchor assemble the anchor and
mount it on the main unit as shown on the diagrams. The top
half of the EV One can be temporarily removed and set aside.
3. Place the anchor in the ground. Route the power supply and
network cable through the anchor and in the EV One. Make
sure the anchor is level and the bottom of the EV One will be
flush with the ground level. Fill the hole with concrete.
4. Connect the power supply cable according to the connection
diagram. Connect the network cable to the Smappee Connect
inside the EV One.
5. Switch on the power using the circuit breaker.
6. Download the Smappee App and follow the instructions to
configure the Smappee Charging Station.
7. Slide the outer housing onto the EV one and tighten the screws
at the bottom. Attach the door with the supplied door screws.
8. Hand over the QR codes and the Smappee Charge Card to the
owner.