TREX TX-380MB RIGON Bedienungsanleitung Seite 67

G B C L E A N I N G A N D M A I N T E N A N C E
1. Regular maintenance of the device should be considered. It should be carried out at least every 20 hours
of operation of the device.
2. Maintenance includes:
• checking on moving parts of the equipment and keeping them greased. It is recommended to use bicycle
bearing greases or multi-component greases for fitness equipment.
• taking care of other parts of the device, i.e.tightening bolts and nuts,
• checking power cords (if present in the device) for damage.
3. To clean the equipment it's recommended to use a soft cloth slightly moistened with water or possibly with
soap and water. Do not use strong substances or sharp cleaning materials that can damage the equipment.
Particular care should be taken with plastic components.
4. After each use, remove all traces of sweat and dirt from the device.
G B T R O U B L E S H O O T I N G
Problem
The computer doesn't
display data.
The device makes distur-
bing sounds during use.
The computer doesn't
display the heartbeat or the
values are incorrect.
The equipment is unstable.
Possible solution
1. Disassemble the computer and check if the cables are correctly
connected and are not damaged.
2. Check if the batteries are inserted correctly.
3. If batteries in the computer are exhausted replace them with the
new ones.
Check if all parts of the device are installed correctly. Tighten the
screws.
1. Make sure that the pulse sensor and computer cables are properly
connected.
2. To ensure correct pulse reading, hold both hands on the sensors.
Remember that the measurements may be slightly inaccurate. Do
not clamp your hands on the sensors too much as it may cause
measurement errors.
3. Do not clamp your hands on the sensors too much as it may cause
measurement errors.
Turn the end of the rear stabilizer to level the device.
59