TREX TX-380MB RIGON Bedienungsanleitung Seite 57

G B A S S E M B LY
2
UUnscrew the screw (14), remove the curved washer (47), screws (79), and flat washers (46) from
the main frame (1) using an Allen key.
Thread the resistance regulator cable (23) through the lower hole of the steering column (5) and
pull it out through the square hole of the steering column (5).
Connect the sensor cable (22) from the main frame (1) to the sensor extension cable (20) from
the steering column (5).
Place the steering column cover (21) on the steering column (5) and position the steering column
(5) on the main frame tube (1). Secure with the screw (14), curved washer (47), screws (79), and
flat washers (46) that were previously removed. Tighten with an Allen key.
Unscrew the screw (17) and remove the curved washer (16) from the resistance adjustment
knob (15) using a multifunction tool.
Attach the resistance regulator cable (15) to the metal sensor cable holder (23) as shown in
Figure A. Then, pull the resistance regulator cable (15) upward and insert it into the slot of the
metal sensor cable holder (23) as shown in Figure B.
Attach the resistance adjustment knob (15) to the steering column (5) using the screw (17) and
curved washer (16) that were previously removed. Tighten the screw using a multifunction tool.
49