Costway TQ10167DE Bedienungsanleitung Seite 11

Troubleshooting Guide
Car will not run at all.
Check all electrical connections and ensure there is no
damage.
Car is running slower than normal.
Stop using the toy and recharge battery
WARNING
Never leave child unattended.
Avoid serious injury from falling or sliding out. Always use
seat belt.
Parcels or accessory items, or both, placed on the unit may
cause the unit to become unstable.
Specifications
The battery
12V7AH*1
Two driving motors (12V30W* 2RPM13000)
The motor
Steering motor (12V20W* 1RPM6000)
The charger
12V1000MA
Maximum load
30kg / 66lbs
The car speed
2.5KM/H-5.5KM/H
20
Maintenance:
● Parents should check whether the main parts are in good
condition before use. Check if the battery, wire, plug, shell
and other parts are damaged, whether the nut is loose,
whether there is potential safety hazard and stop using until it
is repaired.
● After a period of use, lubricate the iron parts of the vehicle
with a small amount of lubricating oil to prevent wear and rust.
● The vehicle shall be placed far away from the fire source
and avoid long-term light. The storage shall be placed flat
towards the front, and shall not be reversed or tilted. In humid
weather, such as near the fire stove and heater, the plastic
part may melt. When charging, keep away from inflammable
objects to prevent fire.
● Please charge the battery in time after use. The charging
must be operated by adults. If the battery is stored or not
used for a long time, it must be fully charged first and then
charged at least once a month to extend the battery life.
● Wipe the vehicle with dry soft cloth, or wipe the plastic parts
with non wax furniture polish instead of soft cloth, so as to
achieve the surface finish effect. Do not use chemical solvent
to wipe the plastic part of the toy. Do not wash the vehicle
with soap and water. Do not drive the vehicle in rainy or
snowy weather. Water can damage motors, vehicle electrical
systems and batteries.
● When you stop using or placing a new product, please cut
off the power supply of the product and pull all switches to the
"stop" or "off' position.
● Do not use fuses that do not conform to the specifications
of this product.
● Do not change the structure and circuit system of the
product without permission, and the maintenance work must
be conducted under the guidance of professional or technical
personnel.
21