HOMCOM 800-181V70 Bedienungsanleitung Seite 4

EN
ATTENTION: Do not spill water on the base.
4. Close the lid.
5. Place the jug on the base, then insert the plug into the wall socket. Push the 'on/off'
switch – the 'on/off' light will illuminate.
6. The jug kettle is now switched on – the water will begin to heat. When the water has
come to a boil, the kettle will switch off automatically after a few seconds.
7. Using the handle, remove the jug from the base and pour the water out.
ATTENTION: To prevent scalding, do not touch the hot water.
8. If you want to heat water without boiling it, you can switch the kettle off at any time.
9. When finished with the kettle, remove the plug from the wall socket.
Overheating safeguard
This kettle has an overheating safeguard. It will switch the kettle off if it is used
without(sufficient) water. Before using the kettle again, allow it to cool down for at least
10 minutes.
CLEANING AND MAINTENANCE
Unplug the appliance and wait for it to cool down.
•
Clean the jug with a damp cloth. Never immerse the appliance in water. Never put the
•
appliance in a dishwasher. Do not allow the electrical connections to become damp.
If the interior of the jug becomes severely discoloured, clean it with a damp cloth and a
•
little washing soda. After cleaning, rinse the jug very thoroughly.
ATTENTION:
• Never use corrosive or scouring cleaning agents or sharp objects (such as
knives or hard brushes) to clean the appliance.
Before cleaning, unplug the appliance and wait for it to cool down.
•
DESCALING DESCALING
This appliance has an integral heating element, which means limescale will not form.
•
You do not need to descale this appliance.
If you still wish to descale this appliance, follow these steps:
•
1. Unplug the appliance and wait for it to cool down.
2. The kettle has a descaling filter. Remove the filter when cleaning.
3. Fill the jug to the 'max' level with vinegar solution, then bring to a boil.
4. Leave the jug with the vinegar solution to stand for a couple of hours.
5. Empty the jug, fill to the 'max' level with clean water and bring to a boil. Empty the jug.
Repeat this process twice.
Never use ammonia or other products to descale the appliance. Only use a
•
vinegar solution or special descaling agents.
4