Dell PowerEdge 6850 serie Handbuch Seite 21

Figure 1-11. Cabling the Peripheral Interposer Board
1
1 control panel
4 backplane power
9 Remove the peripheral interposer board:
Press the spring-loaded blue retention tab at the back of the interposer board, then slide the board
a
upward. See Figure 1-12.
When the board cannot slide upward any farther, pull the board toward the back of the system
b
to remove it from the retention hooks.
Lift the board out of the system, being careful to avoid damaging components on the face
c
of the board.
Disconnect the backplane power cable from the front of the interposer board and place
d
the backplane power cable aside. See Figure 1-11.
Place the interposer board aside on a work surface.
e
2
2 power
3
4
3 data interface cable
SAS Information Update
19