Dell Networking N1500 Serie Handbuch Zum Einstieg Seite 129

Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly as
possible. You can skip the setup wizard, and enter CLI mode
to manually configure the switch. You must respond to the
next question to run the setup wizard within 60 seconds,
otherwise the system will continue with normal operation
using the default system configuration. Note: You can exit
the setup wizard at any point by entering [ctrl+z].
Would you like to run the setup wizard (you must answer this
question within 60 seconds)? [Y/N] y
Step 1:
The system is not set up for SNMP management by default. To
manage the switch using SNMP (required for Dell Network
Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and set up other SNMP accounts. (For
information on setting up an SNMP version 1 or
see the user documentation).
Would you like to set up the SNMP management interface now?
[Y/N] y
To set up the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to
access the switch. The wizard automatically assigns the
highest access level [Privilege Level 15] to this account.
You can use Dell Network Manager or other management
interfaces to change this setting, and to add additional
management system information later. For more information on
adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used. [public]:
public
Руководство по началу работы
more
3 account,
129