Rack Mounting The N1500 Series Switch; Installing In A Rack - Dell Networking N1500 Serie Handbuch Zum Einstieg

Rack Mounting the N1500 Series Switch

WARNING:
as well as the safety information for other switches that connect to or support
the switch.
The AC power connector is on the back panel of the switch.

Installing in a Rack

WARNING:
a table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches
from the bottom up.
1 Place the supplied rack-mounting bracket on one side of the switch,
ensuring that the mounting holes on the switch line up to the mounting
holes in the rack-mounting bracket. Figure 1-6 illustrates where to mount
the brackets.
Figure 1-6. Attaching the Brackets
2 Insert the supplied bolts into the rack-mounting holes and tighten with
a screwdriver.
3 Repeat the process for the rack-mounting bracket on the other side of
the switch.
Read the safety information in the
Do not use rack mounting kits to suspend the switch from under
Safety and Regulatory Information
Getting Started Guide
17