Tips And Recommendations For Installation; Restoring The Original Configuration - SOMFY ilmo 50 WT Anleitung

2. 4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2. 4. 1. Questions concerning the ilmo 50 WT?
Problems
The roller shutter The wiring is incorrect.
is turning in the
wrong direction.
The roller shutter The wiring is incorrect.
is not operational.
The drive is hot.
The control point is not compatible.
The roller shutter The roller shutter is encountering
stops too soon. friction when it moves: friction along
the runners and case, interference
between the roller tube and the
drive, etc.
The drive has been installed in a new
roller shutter.
The roller shutter The mountings used are not correct. Check that the roller shutter is mounted to
does not stop
when it reaches
the lower end limit
position.
The roller shutter The roller shutter locking system in
does not stop the upper position is not correct.
when it reaches
the upper end limit
position.
2. 4. 2. Restoring the original configuration
2. 4. 2. 1. Using the control point connected to the roller shutter
Follow each of the 4 steps in the procedure carefully to correctly restore the original configuration.
Place the roller shutter in the mid-height position.
1)
Repeat the next step 3 times in succession:
2)
Press the Up button until the roller shutter moves. Release
•
the button immediately.
Repeat the next step twice in succession:
3)
Press the Down button until the roller shutter moves.
•
Release the button immediately.
Press the Down button again until the roller shutter makes
4)
2 successive movements in the same direction.
The motorisation is reset to the original configuration.
•
2. 4. 2. 2. Using the wired electronic motor setting tool
Press the Up and Down buttons on the setting tool at the
-
same time until the roller shutter makes two successive up
and down movements.
The drive has been restored with the original configuration.
•
Copyright © 2015 Somfy SAS. All rights reserved.
Possible causes Solutions
Check the wiring and modify it if
necessary.
Check the wiring and modify it if
necessary.
Wait for the motor to cool down.
Check for compatibility and replace the
control point if necessary.
Check the roller shutter installation and
correct any friction.
If the problem continues, restore the drive
to its original configuration.
Restore the drive to its original
configuration, see the section entitled
"Restoring the original configuration".
the roller tube using rigid links.
Check that the roller shutter is fitted with
end stops screwed onto the last slat, fixed
or removable stops incorporated in the
runners or an end slat acting as an end
stop.
1
3
x 2
7s
Images not contractually binding
EN
2
x 3
4
19