Bosch PFS 65 Originalbetriebsanleitung Seite 20

20 | English
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60335 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 19.12.2007
Assembly
Before any work on the machine itself, pull
the mains plug.
Connecting the Air hose
(see figures A1
–
– Open the holding clamp 16 and unreel the air
hose 13.
Connecting to the spray gun:
– Firmly insert an SDS connector 14 of the air
hose in alignment with the arrow mark into
the hose port of the spray gun 6.
– Turn the SDS connector until the lock can be
heard to latch.
Connecting the base unit:
– Firmly insert the second SDS connector of
the air hose in alignment with the arrow mark
into the port of the base unit 19.
– Turn the SDS connector until the lock can be
heard to latch.
1 609 929 R18 | (7.5.09)
Dr. Eckerhard Strötgen
Head of Product
Certification
A2)
Fastening the Carrying Strap
(see figure B)
In order to reach all surfaces to be sprayed and
maintain flexibility, you can sling on the base
unit with the carrying strap 20.
– Attach one strap end to each eyelet 17.
Operation
Preparing for Operation
Spraying on the sides of water bodies
(lakes, rivers, etc.) or neighbouring surfac-
es in the direct catchment area is not per-
mitted.
When purchasing paint, varnish and spray mate-
rial, pay attention to their environmental com-
patibility.
Preparing the Spray Surface
Note: Cover off the vicinity of the spray surface
thoroughly and generously.
The spray mist contaminates the environment.
When spraying in enclosures, surfaces not cov-
ered can become contaminated.
The spray surface must be clean, dry and
grease-free.
– Roughen smooth surfaces and then remove
the sanding dust.
Diluting Spray Material
When diluting, pay attention that the spray
material and the diluting agent correspond.
When using a faulty diluting agent, lumps can
develop that can lead to clogging of the spray
gun.
Spray material
Wood preservatives,
strippers, oils, finishes
Disinfectants,
plant protectants
Solvent- or water-dilutable
paints, primers,
automobile spray paint,
thick-coat finishes
Recommended
dilution
undiluted
undiluted
At least
10 % diluted
Bosch Power Tools